Feature:

Door / window installation magnetic sensor charge batteries in part a of the wireless door / window magnets and attach it to doors / window frames to be monitored, and part B on the doors / windows as close to each other as possible, as shown in Figure.

We recommend securing parts A and B with screws.

The screw holes of part One are located on the mounting plate, which must be drilled using hard objects.

Door / window test magnetic sensor:

After installation, pull the antenna towards the entire body.

Open the doors / windows to be monitored, the red light on the magnet will be on, at the same time there will be alarming sounds and indication on the console and the device.

If the red light on the magnet is not on, please check if the "Low volt indicator" is on.

If it is, replace the batteries.

Specification:

Working voltage: DC CR2032 3V

Working current: 12MA

Transmission frequency: 433MHZ

Quiescent current: 3uA

Launch distance: 100M

Magnetic control effective distance: suction -15mm; release -30mm

Current consumption: less than 20uA; less than 15mA during transmission

transmit Freqency: 433 ± 0. 2 Mhz

transmit Duration: less than 1 s

transmit Distance from the host: more than 80 m (without obstacles)

installation: less than 15mm between part A and part B

Type of coding: Learning Code 1527 chips

humidity: less than 90%

Shell Color: White

Note: This sensor only suit for the 1527 types, 433 mhz alarm system